Best window film for heat reduction

Quick answer: For most San Antonio homes, the best window film for heat reduction is a spectrally selective film like 3M Prestige. Prestige 70 keeps 69% of daylight and rejects 50% of the sun’s heat, and darker shades reject up to 62%. 3M Night Vision 15 rejects about 72% but darkens the glass. Compare films by total solar energy rejected (TSER).

We’ve put film on more than 5,000 homes around San Antonio since 1989, and we’re one of only two 3M Prestige Dealers in the city. Below are 3M’s own numbers, the one spec worth asking any installer for, and which windows to start with.

Two-story limestone home in the San Antonio area with Fletch window film
Window film on a two-story limestone home

How much heat do 3M home window films block?

3M’s data sheets rate its Prestige films at 50% to 62% of the sun’s energy rejected and Night Vision 15 at 72%, on single-pane clear glass. The same glass with no film rejects 18%. In general, the darker the film, the more heat it stops and the more daylight it costs you.

Glass and film Daylight let through Heat rejected (TSER) UV blocked Look from inside
Clear glass, no film 88% 18% 43% Clear
3M Prestige 70 69% 50% 99.9% Nearly clear
3M Prestige 40 39% 60% 99.9% Light neutral tint
3M Prestige 20 21% 62% 99.9% Darker neutral tint
3M Night Vision 15 13% 72% 99.9% Dark, warm smoke

The figures are for 1/4-inch single-pane clear glass, from 3M’s data sheets for Prestige and Night Vision 15. Double-pane glass shifts every number. On double-pane clear glass, 3M puts Night Vision 15 at 60% rejected, up from 30% with no film.

Night Vision 15 wins the heat column outright. It also turns a sunny living room into something like the lobby of a nice steakhouse, which is lovely at dinner and a little strange over cornflakes.

Prestige 70 makes the opposite trade. It gives up some heat rejection and leaves the room looking almost exactly as it did, minus the part where the couch is too hot to sit on.

Does window film really reduce heat?

Yes. Window film reflects and absorbs part of the sun’s energy at the glass, so less of it reaches the room. The International Window Film Association says film does this by lowering the window’s solar heat gain coefficient, and 3M says its home films can cut up to 78% of the sun’s heat coming through the glass.

You’ve already run this test, by the way. Everyone in San Antonio has put a palm flat on a west window at 5pm in July and pulled it back like the glass said something rude.

What you felt is the sun’s energy coming straight through, and it’s why every house here has a room that closes at 4pm. Nobody puts up a sign. The family just stops going in there, and by August it’s where the ironing board and the dog go to think about their choices.

Russell B. (September 2023) put it more politely: “The heat from the direct sunlight was creating an unbearable living space during the 100 degree summer days.” That’s the room. Film is how you get it back without bricking up the window.

Which number tells you how much heat a film blocks?

Total solar energy rejected, or TSER. It’s the share of all the sun’s energy, meaning visible light, infrared and UV, that a film keeps out. The IWFA’s solar control training guide defines it as 1 minus the solar heat gain coefficient. Higher TSER means a cooler window. Infrared rejection measures only one slice of the heat.

That slice matters because, by the IWFA’s numbers, roughly 53% of the sun’s energy arrives as infrared and about 44% as visible light. Visible light heats a room too. A film can stop nearly all the infrared and still let plenty of heat in as light.

3M rates Prestige at up to 97% of infrared rejected, measured between 900 and 1,000 nanometers, and the same films reject 50% to 62% of the total. Both numbers are true. Only one of them tells you how warm the couch gets.

So when a sample card leads with infrared, treat it like the “serves 6” on a frozen lasagna: technically defensible, and nobody in your kitchen believes it. Ask for the TSER on your kind of glass, and ask for it in writing.

Bay window on a home with brown siding, fitted with 3M Night Vision 15
3M Night Vision 15 on a bay window

Do darker window films block more heat?

Usually, yes. For reflective films, the IWFA guide says that in general, the lower the visible light transmission, the higher the heat rejection. Spectrally selective films bend that rule: 3M Prestige 70 lets through 69% of the daylight and still rejects half the sun’s energy.

Dark films come with two catches. The first is obvious: the room gets darker all day, including the February afternoons when you’d quite like the sun back.

The second shows up after dark. A mirror-style film reflects whichever side is brighter, so at night the inside of the window becomes a mirror, and nobody needs a full-length view of themselves eating cereal over the sink at 10pm. Our post on privacy film at night explains the physics.

3M built Night Vision around that problem. It has low interior reflectivity, so 3M says you can still enjoy the view out at night through a dark film.

Brick home with a deck, fitted with 3M TrueVue 15 window film
3M TrueVue 15 on a brick home with a deck

How do you block heat from windows without making the house dark?

Choose a spectrally selective film. These films reject much of the sun’s infrared while letting most visible light through, so the room stays bright. 3M Prestige is built from hundreds of thin layers with no metal in them, blocks 99.9% of UV, and rejects 50% to 62% of the sun’s energy depending on the shade.

No metal matters more than it sounds. 3M says the film won’t interfere with phone signals or corrode, which is great news for your cell reception and terrible news for your favorite excuse for missing your sister’s calls.

If you bought the house for the big windows, you didn’t pay for that glass so you could keep the blinds shut from May to October like a vampire with a mortgage. Prestige is the film for that house, and the 3M Prestige home window film page has the full range.

The easiest way to choose is to feel it. Every quote for heat control window film comes with 3M samples and a heat lamp, and you put your hand on the other side of the glass.

Limestone home with a metal roof, fitted with 3M Prestige window film
3M Prestige on a limestone home with a metal roof

What are other ways to reduce heat from windows?

Solar screens, awnings, exterior shades and interior blinds all cut heat. A Department of Energy lab guide says outside shading usually blocks more heat than anything inside, because it stops sunlight before it passes through the glass. The same guide says films suit warm-hot climates best and can reduce daylight.

A study done for the Department of Energy modeled homes in 12 US cities, San Antonio among them. In cooling-dominated climates, it found, every kind of window attachment saved energy. Down here the question isn’t whether to shade the glass. It’s how much view you’re willing to trade for it.

Blinds work too, if you close them. Most of us close them at 2pm, then leave them that way until the Christmas lights go up.

Solar screens usually stop more raw heat than film on the windows they cover, and they cost you more of the view. We put the two side by side in solar screens vs window film.

Which windows should get heat control film first?

Start with west-facing windows, then south. West glass takes the low afternoon sun at the hottest point of the day, so that’s where homeowners notice film fastest. Sliding glass doors, big picture windows and the room that closes at 4pm come next. North windows in San Antonio rarely need heat film.

Megan S. (April 2024) started with one door: “We were so happy with our first installation on a big sliding glass door that we asked them to come out and do additional windows that get the afternoon sun.”

One week of sitting next to a sliding door without sweating, and you start eyeing every other window in the house like it owes you money.

If doing it in stages suits you, do the west side this year and the rest next spring. The sun isn’t going anywhere. I checked.

Tile-roof home in the San Antonio area
A tile-roof home in the San Antonio area

What we see at the shop

Every home quote we do starts the same way. We hold a heat lamp behind each 3M sample, you put your hand on the other side of the glass, and most people pick their film in about four seconds.

It’s the quickest decision on any home project. Paint takes three weekends, forty sample squares on the living room wall and one tense dinner. Film takes a hand and a heat lamp.

We’ve done this on more than 5,000 homes since 1989, and most homes are finished in a day. R. C. (August 2022) had us film the windows and a storm door, and said the film “has helped a great deal during this torrid summer.” Clirissa H. (July 2022) had her whole house done and said the tint looks great “because you can’t even tell they are there except for the reduced heat coming from them.”

That second review is the compliment I like best. Good heat film is the thing nobody in the house notices, except the dog, who gets the window seat back.

I’ll also tell you when a window doesn’t need film. North glass here rarely earns it, and I’d rather you spend the money on the west side, where the sun is doing the most damage.

And the room that closes at 4pm opens back up. The ironing board will have to find somewhere else to sulk.

Bay window on a San Antonio area home
A bay window on a San Antonio area home

Frequently asked questions

What is the best window film for heat reduction?

For homes where you want to keep the view, a spectrally selective film like 3M Prestige is the usual choice, rejecting 50% to 62% of the sun’s energy depending on the shade. If maximum heat rejection matters more than daylight, 3M Night Vision 15 rejects about 72% on single-pane clear glass.

Does window film reduce heat in a house?

Yes. Film reflects and absorbs part of the sun’s energy at the glass, which lowers the heat that reaches the room. You’ll notice it most on west- and south-facing windows in the afternoon.

Does heat control film go on the inside or outside of the window?

Most home films, including 3M Prestige and Night Vision, go on the inside of the glass. 3M also makes an exterior version of Prestige, which we install, and 3M says outside films work especially well on tinted, reflective or low-e glass. We check your windows before recommending either.

Can I put heat control film on double-pane windows?

Usually, yes, when the film is matched to the glass. Film changes how much heat the glass absorbs, so the installer should check the glass type before recommending a film. Our post on tinting double-pane windows goes deeper.

Will heat control film make my house dark?

Not if you choose a light spectrally selective film. 3M Prestige 70 lets through 69% of visible light while rejecting half the sun’s energy on single-pane clear glass.

How much does heat control window film cost?

At Fletch, home window film runs about $7 to $19 per square foot of glass, installed. The film you choose and the amount of glass set the price, and you get the number in writing before we leave. Our guide to what window film costs explains what moves it.

Get the heat out of your hottest room

Want to feel the difference before you choose? Book a free in-home quote for heat control window film in San Antonio. We’ll bring 3M Prestige and Night Vision samples and a heat lamp, measure your windows, and give you a written price before we leave. For everything else we do for houses, see home window tinting in San Antonio.

Sources

Kevin Fletch Fletcher, co-owner of Fletch Window Tint

Written by Kevin “Fletch” Fletcher, co-owner of Fletch Window Tint

Kevin and his wife Sally have run Fletch Window Tint in San Antonio since 1989. The shop is one of only two 3M Prestige Dealers in the city, with more than 120,000 cars and 5,000 homes tinted. Get a free quote or call (210) 669-2940.